Please be aware that we do not include software for this Item neither on disc nor by downloadįor a General Introduction into diagnostic on BMW vehicles please download / open and read this PDF document carefully:įor information about driver download and installation please download / open and read this PDF document carefully:įor information regarding backward compatibilty for older K-Line equipped vehicles please download / open and read this PDF document carefully:įor information regarding connection issues on DCAN equipped vehicles please download / open and read this PDF document carefully:įor Driver downloads please go directly to the FTDI Driver Page: K+DCAN OBD2 female to OBD2 male Adapter for extended backward compatibility - 1 Ignition voltage detection by control line (See Screenshot) Battery voltage detection by control line (See Screenshot) High Speed D-CAN and PT-CAN support (500 kbit/s) (See Screenshot) Double K-Line support (See Screenshot) Please also read the backward compatibility Application Note Connects to USB (built in 1,5m long USB Cable, creates virtual comport) The smallest, best looking & highest quality of it's kind. Works with INPA, SSS, Progman and all other Ediabas handler based Software. The interface is still fully compatible with those vehicles, however they are not officially supported by the old Ediabas based diagnostic system / software.

(This is only the case for a very small number of vehicles manufactured at the time OBD2 became mandatory) The second exception are F series vehicles, this limitation is actually not caused by the Interface but by the older diagnostic software that does not officially support those vehicles.Į39 and up are fully supported as well - however please be aware that you will need an suitable OBD2 to 20pin adapter cable that is not included with this Interface and must be purchased separatelyĮ34/E36/E38 vehicles are only partially supported, you won't be able to access all modules inside them, if you need full access to them please review our OBD/ADS Interface. There are only two exceptions to this, if you have an older vehicle with both, the OBD2 and the 20pin connector installed the 20pin connector must be used for factory diagnostic since the OBD2 connector will not be fully wired. This Interface allows FULL diagnostic of BMW's build from 1998 - 2013.and moreĮach and every OBD2 equipped vehicle is supported by this Interface.

K dcan cable